APPLICATION
Surface
Preparation: All surfaces must be clean and free from laitance
(efflorescence), dust, dirt, oil and grease.Cracks, joints and pipe outlets
has to be treated as per the SUPERSHIELD specfication.
Primers: No primer is usually
required. Our SBR Based SUPERSHIELD
BONDPLAST is used as a bonding coat to obtain good adhesion
between a bitumen substrate and these water-based roof coatings.
Rusty surfaces require rust control prior to the application
of the roof coats.
Thinning: Can be thinned
with clean water upto 10% to replace evaporation losses
or to adjust with the spray equipment. Caution:
excessive thinning will cause the coating to lose adhesion
and elasticity.
Coverage: Apply THERMOKOTE roof coating @ 500ml/meter square. Product can be
applied in successive coats to increase insulation and waterproofing ability.
Minimal interval of 8 hours required for applying the successive coats.
Application: Roller or
airless spray application is recommended. Very small areas
may be brushed.
Airless Spray:
-
Tip Orifice .031 inches
- Atomizing
Pressure 2200 - 2500 psi
- Fan
Spread 60 Degrees
- Pump
/ Minimum 3.6 liter per minute at 2500 psi
- Filter
/ Remove filters & screens
Mixing: Stir each container
thoroughly using low speed mechanical agitation to avoid
air entrapment.
Warranty: 5 year limited
warranty and extendable upto 10 years *.
